Your Account:
(Your shopping cart is empty)
Pick Your Poison!
Shop by Jeep Model!
Shop by Project!

Call Poison Spyder:



8 AM to 5 PM Pacific

Email Poison Spyder:


  Home > Lighting & Accessories > LED Headlights, Taillights & Markers >

2-1/2" LED Back-Up Light - Clear
2-1/2" LED Back-Up Light - Clear

MSRP: $31.35
Spyder Direct: $28.99
You save $2.36!

PN: 41-04-300


2-1/2" flush mount LED back-up light for use with Poison Spyder Customs Crusher Corners, Trail Corners or any other manufacturer's corner protectors, or anywhere you can cut a 2-3/4" hole in a flat sheetmetal panel. push-in mounting with the included rubber grommet. Sold by each, if you need a pair specify a quantity of 2.


We've heard that some folks were having trouble installing these, so we shot a quick video with some tips. The trick is to soften the rubber grommet up in some warm water before installing. Check out the video for Alex's install tips!

Image Galleries

Here is our entire collection of images for this product. We're constantly adding more photos so check back often if you don't see a shot with a specific angle or installation you are looking for. Do you own this item already? We'd love to have your photos to add to our collection. Just send the hi-res images via email to

Average Customer Review: 4.5 of 5 Total Reviews: 46 Write a review.

  0 of 0 people found the following review helpful:
May 2, 2018
Reviewer: Mike Skeuse from NEW HOPE, PA United States  
Great lights! Fit well and your install tip to use hot water made a big difference!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
Fits perfectly November 3, 2017
Reviewer: Brad H from Pflugerville, TX United States  
Took a little bit to get installed and wired, but works great.

I do wish the instructions for installing in the rock brawler had some well defined instructions. Would have made the process faster.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
Does not fit! August 12, 2017
Reviewer: Fernando Rios from Fort Benning, FL United States  
I bought this lights for my Poison Spyder Rear Rockbrawler Bumper and it is a pain in the back to make it fit. They are pressure pushed through the hole. And when I said; "PRESSURE PRESSED " I mean PRESSURE PRESSED.  I even broke one trying to make it fit. Very disappointed! They have to come up with a light that could fit an be able to hold it from inside bumber. Bumper does not holes for bolts or screws.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
Look good June 24, 2017
Reviewer: Anonymous Person from Ogden, UT United States  
The lights look like good quality. I haven't had a chance to install them. I had gotten around to installing it but I found out that I did not have the right gauge wire. It would be nice if there was a small wiring harness for them I am planning on hooking it up to my reverse lights since I have the connection for it already but it would be nice to have a separate switch. It would also be nice if they came with the tapping screws for the ground wire. I will try and add more when I have them all connected.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
Light into Brwaler II March 26, 2017
Reviewer: Will Smith from Hubert, NC United States  
Light and grommet went in smoothly. Just 20-30 seconds of a hair dryer and both mounted easily. Still quite a bit of pressure to remove even immediately after install.

Was this review helpful to you?

View All Customer Reviews

Browse for more products in the same category as this item:

Lighting & Accessories > LED Headlights, Taillights & Markers
Rear Corner Armor > Crusher Corners™
Rear Corner Armor > JK Crusher Corners™
Jeep JK • 2007-2017 > JK Rear Corner Armor
Jeep TJ - LJ • 1997-2006 > TJ/LJ Rear Corner Armor
Jeep YJ • 1987-1996 > YJ Rear Corner Armor
Jeep CJ • 1976-1986 > CJ Rear Corner Armor
Rear Corner Armor
Lighting & Accessories
Jeep JK • 2007-2017
Jeep TJ - LJ • 1997-2006
Jeep YJ • 1987-1996
Jeep CJ • 1976-1986

Poison Spyder Customs, Inc. is a Proud Member Of:

Poison Spyder urges our customers and ALL 4x4 enthusiasts to join the fight to keep our trails open, and maintain public access to public lands! Please join and support these organizations as well as your local clubs and land-use advocacy groups.

 About Us
 Contact Us
 Customer Service
 Find A Dealer
 Tech Library
 Send Us Feedback